Publicaciones en las que colabora con Pedro Jose Arrazola Arriola (38)

2022

  1. Effect of surface integrity generated by machining on isothermal low cycle fatigue performance of Inconel 718

    Engineering Failure Analysis, Vol. 137

  2. Enhancing surface integrity of A7050-T7451 aluminium alloy by pneumatic machine hammer peening

    Procedia CIRP

  3. Physical modelling with experimental validation of high ductility metal cutting chip formation illustrated by copper machining

    International Journal of Machine Tools and Manufacture, Vol. 173

2021

  1. Experimental and FEM analysis of dry and cryogenic turning of hardened steel 100Cr6 using CBN Wiper tools

    Procedia CIRP

2019

  1. Corrigendum to “Mechanical characterization and modelling of Inconel 718 material behavior for machining process assessment” (Materials Science &Engineering A (2017) 682 (441–453), (S0921509316314071), (10.1016/j.msea.2016.11.054))

    Materials Science and Engineering A

  2. Methodology to establish a hybrid model for prediction of cutting forces and chip thickness in orthogonal cutting condition close to broaching

    International Journal of Advanced Manufacturing Technology, Vol. 101, Núm. 5-8, pp. 1357-1374

2018

  1. Effect of cutting speed on the surface integrity of face milled 7050-T7451 aluminium workpieces

    Procedia CIRP

  2. Experimental and FEM analysis of surface integrity when broaching Ti64

    Procedia CIRP

  3. New calibration method to measure rake face temperature of the tool during dry orthogonal cutting using thermography

    Applied Thermal Engineering, Vol. 137, pp. 74-82

  4. Ti6Al4V metal cutting chip formation experiments and modelling over a wide range of cutting speeds

    Journal of Materials Processing Technology, Vol. 255, pp. 898-913

2017

  1. Effect of Thermal Annealing on Machining-Induced Residual Stresses in Inconel 718

    Journal of Materials Engineering and Performance, Vol. 26, Núm. 8, pp. 3728-3738

  2. Mechanical characterization and modelling of Inconel 718 material behavior for machining process assessment

    Materials Science and Engineering A, Vol. 682, pp. 441-453

2016

  1. Heat transferred to the workpiece based on temperature measurements by IR technique in dry and lubricated drilling of Inconel 718

    Applied Thermal Engineering, Vol. 104, pp. 309-318

  2. Influence of Tool Wear on Residual Stresses When Turning Inconel 718

    Procedia CIRP

  3. Influence of oxygen content on the machinability of Ti-6Al-4V alloy

    International Journal of Advanced Manufacturing Technology, Vol. 86, Núm. 9-12, pp. 2989-3005

  4. Surface Integrity Analysis when Machining Inconel 718 with Conventional and Cryogenic Cooling

    Procedia CIRP

2015

  1. Finding Correlations between Tool Life and Fundamental Dry Cutting Tests in Finishing Turning of Steel

    Procedia Engineering

  2. Uncertainty of temperature measurements in dry orthogonal cutting of titanium alloys

    Infrared Physics and Technology, Vol. 71, pp. 208-216

2014

  1. Analysis of residual stress and work-hardened profiles on Inconel 718 when face turning with large-nose radius tools

    International Journal of Advanced Manufacturing Technology, Vol. 71, Núm. 9-12, pp. 1587-1598

  2. Correlation between tool flank wear, force signals and surface integrity when turning bars of Inconel 718 in finishing conditions

    International Journal of Machining and Machinability of Materials